IR Remote Board  1000 Rev - (designed 8/7/02)


DESCRIPTION:

2 layer 1.690" X 1.060" PCB 
SMT components on both sides
0.031" PCB finished thickness
FR-4 material
1 oz/sq ft COPPER
Silkscreen in WHITE on both the Component and Solder sides over Soldermask
LPI Soldermask on both sides
29 holes -- 2 sizes (0.020" min to 0.035" max)
Hole Sizes:  25 -- 0.020", 4 -- 0.035"
All vias are thru hole, no blind or buried vias
No gold
0.012" min trace width
0.006" min spacing
0.019" min pitch on SMT pads


BOARD FILES:

(Gerber RS-274-X format, units: inch, coordinates: absolute, zero supression: none, mm.nn)
compside.gbr (Gerber RS-274-X format) Component side copper
compsilk.gbr (Gerber RS-274-X format) Component side silkscreen
csoldmsk.gbr (Gerber RS-274-X format) Component side soldermask (5 mil larger than pads)
compassy.gbr (Gerber RS-274-X format) Component side assembly (not used in PCB fab)
soldside.gbr (Gerber RS-274-X format) Solder side copper
soldsilk.gbr (Gerber RS-274-X format) Solder side silkscreen
ssoldmsk.gbr (Gerber RS-274-X format) Solder side soldermask (15 mil larger than pads)
soldassy.gbr (Gerber RS-274-X format) Solder side assembly (not used in PCB fab)
drilldim.gbr (Gerber RS-274-X format) Dimensions and holes (pseudo drill drawing)
irremote.drl (Excellon format) Tool Rack File
irremote.th (Excellon format) Drill info for all thru holes
readme.txt (text) this file

Board was designed using IVEX WinBoard ver 2.25
IVEX WinBoard file ==> irremote.brd (not included in PCB fab package)

NOTE: Origin is the upper left hand corner (0,0) with X positive to the right and Y positive down (NOT the lower 
left hand corner with X positive to the right and Y positive up).  This convention will cause the Excellon drill file 
(irremote.th) to appear mirrored about the X axis.  Either mirror and align the drill files with the Gerber files or 
drill from the solder side.

NOTE: There are 5 elastomer button contact pads (S1 thru S5) on the solder side of the PCB.   These are not 
SMT pads.  Keep soldermask off of these pads.  Solder side soldermask is 15 mil larger than the pads to force 
this to occur.


CONTACT INFO:

Designer:		

Contact:		

